PS.10ProSurfaces
Sistema 10
Trowelled epoxy mortar system for industrial flooring 6–10 mm thick with non-slip finish
ProSurfacesSystemsPS.10
Specification item
Multi-layer resin system with a ‘trowel-applied mortar’ finish, specifically designed for high-strength industrial flooring. Waterproof, with good chemical resistance (acid or alkaline solutions). Thanks to its thickness of 0.6 - 1.2 cm, it is the ideal solution for covering and renovating old flooring, even in advanced stages of deterioration.
Technical specifications
Application
The application cycle in 4 steps. The drawing shows each layer as it goes down.
Step 1 / 4
Epoxy primer
Application by roller of the first coat of EPOXITE PF300-T epoxy resin primer, diluted with 50% water.
Step 2 / 4
Epoxy screed
Installation of the three-component epoxy screed EPOXITE MAX, applied using screed guides and a steel straightedge to the required thickness (0.6–1.0 cm). Subsequently, the surface is compacted and floated using a steel trowel or a power trowel.
Step 3 / 4
Two skim coats on the screed
Double skim coating of the screed with VITROX RA500-C coloured epoxy resin applied with a smooth trowel.
Step 4 / 4
Coloured finishing coat
Application of the second coat of colored VITROX RA500-C epoxy resin, dilutable up to a maximum of 10% with DAE thinner, using a trowel. After application, the fresh product is back-rolled using a medium-pile roller.
Products in this system 3
Information on PS.10 Sistema 10
Cycles, coverage, samples: write to us and we will reply with the right system for your job site.
