Specification item
A 3 mm multi-layer system with a monochromatic textured effect, to be applied following substrate preparation with a special fibre-reinforced micro-resin paste, allowing a full double skim coat with embedded fibreglass mesh, followed by two coats of fine or medium-grain micro-resin, protected by a coating of aliphatic polyurethane resin that is scratch-resistant and waterproofing, HACCP certified.
Technical specifications
Application
The application cycle in 6 steps. The drawing shows each layer as it goes down.
Step 1 / 6
Bonding primer
Roller application of the first coat of single-component primer CROMATERIA PRIMER.
Step 2 / 6
Mesh-reinforced skim coat
Substrate skim coat with embedded alkali-resistant fibreglass mesh PRONET 100, using single-component mortar CROMATERIA FONDO/INTERMEDIO applied with a smooth trowel.
Step 3 / 6
Levelling skim coat
Zero-level smoothing with a smooth trowel using single-component mortar CROMATERIA FONDO/INTERMEDIO.
Step 4 / 6
Two coats of decorative finish
Double decorative finishing coat using CROMATERIA FINITURA 02 or 06 applied with a smooth trowel.
Step 5 / 6
Base coat of the protective sealer
Roller application of primer made with CROMATERIA TOP diluted 50% with water.
Step 6 / 6
Two coats of clear finish
Application with roller or plastic smooth trowel of two coats of transparent finish made with CROMATERIA TOP.
Products in this system 4
Information on C.01 Wall
Cycles, coverage, samples: write to us and we will reply with the right system for your job site.
