WP.05WaterProof
Purain Flakes
Elastic, waterproof, multi-layer system with high walkability, with a coloured chip finish
WaterProofSystemsWP.05
Specification item
Elastic waterproof coating for outdoor use on floors, balconies, terraces or walkways where a continuous multicoloured decorative system is required with medium-high traffic resistance and excellent performance such as resistance to UV rays, water stagnation, frequent foot traffic, resistance to sub-zero temperatures and high chemical resistance to staining substances.
Technical specifications
Application
The application cycle in 3 steps. The drawing shows each layer as it goes down.
Step 1 / 3
Primer and perimeter sealing
Apply one coat of ready-to-use PURAIN PRIMER with a brush or specific roller on flooring and vertical surfaces. After drying, coat the perimeter surfaces with PROJOINT.
Step 2 / 3
Two coats of waterproofing with flake broadcast
Pour 50% by weight of PROQUARZ into PURAIN COLOR and mix with a low-speed drill with a helical rod until a homogeneous mixture is obtained. Apply evenly and uniformly with a smooth trowel and, while the second coat is still fresh, proceed with the seeding of COLOR FLAKES in the desired tint.
Step 3 / 3
Two coats of clear finish
Vacuum or remove with a bristle brush any excess multicoloured COLOR FLAKES that have not stuck to the coloured paint previously applied. Then apply two coats of PURTOP VF200-T to the substrate using a plastic trowel, applying the first coat so as to completely impregnate the COLOR FLAKES. Once the film is dry (wait at least 12 hours), apply a second coat with a brush or specific roller, taking care to distribute it evenly and uniformly.
Products in this system 3
Information on WP.05 Purain Flakes
Cycles, coverage, samples: write to us and we will reply with the right system for your job site.
