WP.10WaterProof
Guaina Termoriflettente
Waterproofing system based on elastomeric resin formulated with 3M Glass Bubbles
WaterProofSystemsWP.10
Specification item
White single-component elastomeric coating, based on polymers in aqueous emulsion and special additives, flexible, weather-resistant, with high solar reflectivity and infrared emissivity, capable of increasing the diffused light and efficiency of photovoltaic panels, reducing the surface temperature of the bituminous waterproofing membrane during daylight hours, promoting the dissipation of heat accumulated during the night and consequently resulting in significant energy savings for building air conditioning. The coating has a solar reflectivity (ASTM C-1549) of 0.82, infrared emissivity (ASTM C-1471) of 0.90 and a Solar Reflectance Index (SRI) of 105%.
Technical specifications
Application
The application cycle in 3 steps. The drawing shows each layer as it goes down.
Step 1 / 3
Bonding primer
Apply an even coat of GUAINA PRIMER (diluted 100% with water) using a wide brush or specific roller on the floors and vertical surfaces to be waterproofed.
Step 2 / 3
Perimeter reinforcement and first reflective coat
Once the primer is dry, coat the perimeters and roof drains with TFV 225 (225 g/m² fiberglass fabric), embedding them with ready-to-use GUAINA PRIMER or PROJOINT (single-component polyurethane sealant). Next, apply an even first coat of GUAINA TERMORIFLETTENTE over the entire surface using a resin roller (6-8 mm nap) or wide brush. While still wet, unroll the pre-cut TFV 225 fabric, pressing it with a dry roller to fully saturate it and remove any bubbles or creases.
Step 3 / 3
Second reflective coat
Once the first coat is dry (at least 8 hours at >20°C), apply a second, even coat of GUAINA TERMORIFLETTENTE over the entire surface using a resin roller (6-8 mm nap).
Products in this system 2
Information on WP.10 Guaina Termoriflettente
Cycles, coverage, samples: write to us and we will reply with the right system for your job site.
