WP.11WaterProof
Elastocem
Thin-layer elastic cementitious waterproofing system for balconies and terraces
WaterProofSystemsWP.11
Specification item
Elastic cementitious waterproofing membrane ideal for waterproofing horizontal and vertical surfaces under tiles.
Technical specifications
Application
The application cycle in 3 steps. The drawing shows each layer as it goes down.
Step 1 / 3
Bonding primer
Apply GUAINA PRIMER diluted 100% with water on cementitious substrates or diluted 50% on bituminous membranes, including slate. Apply one coat of the diluted product using a flat brush or long-haired roller on the flooring to be coated and on the vertical surfaces that will be involved in the subsequent waterproofing cycle, taking care to distribute it evenly and uniformly. Seal the perimeter areas and roof drains with PROJOINT (single-component polyurethane sealant), taking care to wait for the previously applied primer to dry.
Step 2 / 3
Reinforcement and first coat of flexible mortar
Cover the perimeter surfaces to be waterproofed with TFV 225 (TFV 225 g/m² fibreglass fabric), gluing them with ELASTOCEM using a roller or brush. After covering all the perimeter areas and roof drains, proceed with the direct impregnation of the pre-cut TFV 225 g/m² with ELASTOCEM using a resin roller (textured pile length 6-8 mm), taking care to distribute it evenly and uniformly until it is completely impregnated, pressing it down with the roller without product to eliminate bubbles or creases.
Step 3 / 3
Second coat of flexible mortar
Apply the second coat of ELASTOCEM, taking care to distribute it evenly and uniformly over the surface to be waterproofed using a resin roller (textured pile length 6-8 mm) over the entire surface to be waterproofed.
Products in this system 2
Information on WP.11 Elastocem
Cycles, coverage, samples: write to us and we will reply with the right system for your job site.
