WP.08WaterProof
Guaina Pedonabile
Liquid waterproofing system based on silanised acrylic resin for cementitious screeds or bituminous membranes, including those with slate covering.
WaterProofSystemsWP.08
Specification item
Silanised acrylic elastomeric waterproofing membrane for waterproofing horizontal and vertical surfaces.
Technical specifications
Application
The application cycle in 4 steps. The drawing shows each layer as it goes down.
Step 1 / 4
Primer and perimeter sealing
Apply an even coat of GUAINA PRIMER (diluted 100% with water on cementitious substrates or 50% on bituminous membranes) using a wide brush or long-nap roller on floors and vertical surfaces. Once dry, seal the perimeters and roof drains with PROJOINT.
Step 2 / 4
Glass-fibre fabric reinforcement
Coat the perimeters and roof drains with TFV 225 (225 g/m² fiberglass fabric), embedding them with GUAINA PRIMER. Then, fully saturate the pre-cut fabric over the entire surface with GUAINA PRIMER using a resin roller (6-8 mm nap), pressing it with a dry roller to eliminate any bubbles or creases.
Step 3 / 4
Two coats of walkable membrane
Once the primer has dried (at least 8 hours at >20°C), apply two even coats of GUAINA PEDONABILE FIBRORINFORZATA (fiber-reinforced walkable coating), allowing 12 hours between coats. Use a resin roller (6-8 mm nap).
Step 4 / 4
Protective clear finish
To enhance foot traffic resistance or facilitate rain self-cleaning (lotus effect), apply one coat of POLIUTEK VF300-T glossy transparent polyurethane resin.
Products in this system 3
Information on WP.08 Guaina Pedonabile
Cycles, coverage, samples: write to us and we will reply with the right system for your job site.
